Driveway Sealing That Lasts 25 Years, Not 2
Most driveway sealers are film-forming coatings. They sit on top of the concrete or pavers, then crack, flake, and turn cloudy after a couple of seasons - so you are back to stripping and re-coating.
DuraSeal uses a penetrating sealer instead. It absorbs into the concrete or paver material itself, so there is no surface film to peel and nothing slippery underfoot. It repels water, oil, and salt from the inside, stabilizes joint sand on paver driveways, and keeps the surface from graying out under UV.
Every driveway we seal is covered by a 25-year transferable warranty. We serve North Carolina, South Carolina, Georgia, and Florida.
Why most driveway sealers fail in two or three years
Nearly every sealer sold for driveways is a film-former: an acrylic or urethane coating that dries on top of the slab or the pavers. It looks great the week it goes down. Then the Southeast happens to it. Summer surface temperatures on an open driveway routinely run 130 degrees or hotter, afternoon storms soak the slab, and the moisture that gets underneath the film has nowhere to go. It pushes back up, hazes the coating white (installers call it blushing), and lifts the edges. Tires do the rest: hot tire pickup peels the film right off in patches wherever you park.
Once a film fails, you cannot simply put more on top. The old coating has to be stripped chemically or ground off before anything new will bond, which is why the second application always costs more than the first. That is the two to three year cycle most homeowners get stuck in.
DuraSeal is a penetrating sealer. It soaks into the concrete or paver and cures inside the pores instead of forming a skin on the surface. There is no film to peel, no film to blush, and no film for a hot tire to pull up. The driveway still looks like concrete or like pavers, only it stops drinking water, oil, and salt.
What a penetrating sealer actually stops
- Water and freeze damage. Water sitting in the pores is what spalls concrete and pops the surface off in flakes after a cold snap. Sealed pores mean far less water in the slab to begin with.
- Oil and transmission drips. On unsealed concrete a drip wicks straight in and becomes permanent. On a sealed driveway it stays near the surface long enough to be cleaned up.
- De-icing and coastal salt. Salt is what eats concrete from the inside in coastal Carolina and Georgia neighborhoods. Repelling it from within is the whole point.
- UV graying and color loss. Pavers hold their color instead of chalking out to gray after a few summers.
- Joint sand washout, weeds and ants. On paver driveways the sealer stabilizes the sand in the joints, so storms stop flushing it out and weeds and ants lose the loose sand they need.
- Slippery surfaces. Because nothing sits on top, traction is unchanged wet or dry. No gloss, no skating rink at the bottom of a sloped drive.
Our driveway sealing process, step by step
- Free on-site quote. We measure the driveway, look at surface condition, oil staining, cracks and drainage, and give you a written price before anything starts. You can also start online with InstaQuote or call 888-660-0260.
- Deep clean. Surface cleaning at the right pressure and, where needed, a cleaning solution for oil, rust, algae and tire marks. A penetrating sealer only works if the pores are open and clean, so this step is not rushed.
- Repairs and joint sand. On paver driveways we top up joint sand where storms have washed it out and reset loose pavers where practical. We tell you honestly when something is a hardscape repair rather than a sealing job.
- Dry down. The surface has to be dry enough to absorb the sealer instead of holding it on damp concrete, so we schedule around weather rather than forcing it.
- Application. The penetrating sealer is applied to full saturation across the whole driveway, including the apron and any walkway added to the job.
- Walkthrough. We walk the finished driveway with you, cover cure times, and register your 25-year transferable warranty.
Concrete driveways vs paver driveways
Both get the same penetrating chemistry, but they behave differently. Poured concrete is one large surface with control joints, so the win is oil resistance, less water in the slab, and less spalling and staining. Paver driveways are hundreds of individual units with sand between them, so the win is color retention plus stabilized joints, which is what cuts down weeds, ants and annual sand top-ups. Stamped and colored concrete keeps its tone without the plastic gloss a film-forming acrylic gives it.
The 25-year transferable warranty
In plain English: if our sealer does not protect your driveway the way we said it would, we come back and make it right at no charge, for up to 25 years. Sell the house and the warranty transfers to the new owner. It covers the performance of the product and our application. It does not cover pre-existing conditions such as cracks, spalling or settlement that were there before we started, and it does not replace normal cleaning. Full written terms are provided at installation.
Driveway sealing FAQ
How long does a driveway take?
Most residential driveways are a one-day job: clean, dry down, seal. Very large or heavily stained driveways can run into a second day, and we tell you which yours is at the quote.
How soon can I drive on it?
Foot traffic returns the same day in most conditions and vehicles typically the next day. Your crew gives you exact cure times for your surface and the weather that week.
Will it change how my driveway looks?
There is no glossy coating. Concrete still looks like concrete. Pavers look richer and truer to their original color because the surface stops being chalky, but you do not get the wet plastic shine of a film-forming sealer.
Is it slippery when wet?
No. Nothing sits on top of the surface, so traction is essentially unchanged. That matters most on sloped driveways and on the apron by the street.
My driveway already has a sealer on it that is peeling. Can you still help?
Usually yes, but the old film has to come off first so ours can get into the concrete. We assess that at the quote and price the removal separately rather than sealing over a failing coating.
Will it get rid of existing oil stains?
Cleaning lifts a lot of them, but a stain that has been soaking into bare concrete for years may not come out completely. Sealing prevents the next one. We will tell you at the quote what we think is realistic instead of promising a perfect slab.
What about cracks?
Sealer is not a structural repair. It will not close a crack or lift a settled section. We point out what we see and let you decide whether to have concrete work done before we seal.
Do I have to reseal every couple of years?
No. That is the film-forming cycle we are replacing. Our penetrating sealer is warranted for 25 years and transfers if you sell the home. Normal washing is still on you, the way it would be with any driveway.
Do you do the walkway and garage apron too?
Yes, and most homeowners add them. Walkways, aprons, front steps, patios and pool decks are all commonly done at the same visit, which is cheaper than bringing a crew back out later.
Get a free driveway quote
Quotes are free, on-site and written down. No pressure, no subscription, no coming back every other spring. Call 888-660-0260, use InstaQuote for a fast ballpark, or send us a message and we will get a crew out to you. We serve North Carolina, South Carolina, Georgia and Florida with local crews, and we are rated 4.9 stars across 450+ Google reviews.